Arctic Dual Hood

• Intended for use at flow rates up to 110CFM.
• Exhaust and intake air cross-contamination was shown to be below the ASHRAE Standard 62.2 limit of 10%.
• Designed to be used with the Broan Tandem Transition Kit (must be purchased separately).

This is a Custom Order Product. All Sales Final.

The Arctic Dual Hood for Heat Recovery Ventilation is compatible with the Broan Tandem Transition Kit (to be purchased separately). The Broan Tandem Transition Kit needs to be in place (all parts except for the actual hood) before installing the Arctic Dual Hood. The Arctic Dual Hood then mounts directly onto the Broan wall mounting plate that is installed as a part of the Broan Tandem Transition Kit. The top two screws that mount the Broan wall mounting plate onto a wall must be out before snapping the Arctic Dual Hood into the Broan wall mounting plate. The top two screws of the Broan wall mounting plate are then screwed into the wall through both the Arctic Dual Hood and the Broan wall mounting plate. In normal situations, the two bottom screws of the Broan wall mounting plate are screwed into the wall before the Arctic Dual Hood is snapped in, and thus those two bottom screws only hold the Broan wall mounting plate (the back of the Arctic Dual Hood has pockets for the screw heads to allow the Arctic Dual Hood to sit flush on the Broan wall mounting plate). Where added security is needed, such as in windy locations, it is recommended to drill screw holes through the Arctic Dual Hood and use washers (field supplied) to run the two bottom screws through both the Arctic Dual Hood as well as the Broan wall mounting plate.

Domestic & International Shipping Available.